Alcohol filling equipment filling quantity are not allowed to do
Alcohol filling equipment filling quantity are not allowed to do at present, the increase in the number of alcoholic commodities has on the market, the alcohol filling equipment precision forward strengths are presented, the precision of the filling into reflect the primary factor of liquor filling machine function, the continuous expansion of production, product quality requirements, filling effects of precision in the production of more and more significant, importance is becoming more and more high.
First said the alcohol filling equipment filling quantity not or discharging of such failure reasons: 1, speed, throttle valve and the filling interval throttle valve is closed, throttle valve cannot be closed;
2, whether there is foreign body inside the fast loading the 3-way valve, if yes, please arrange, fast loading the 3-way valve and filling head whether there is air inside the hose, if there is air, as far as possible to reduce or eliminate the air;
3, all the sealing ring is damaged, if damaged, please replace the new;
4, filling nozzle valve core is there a card or delay to open the plug phenomenon, if there is any card, want to install the valve core to good direction.
Such as delay to open the throttle valve to regulate thin cylinder;
5, fast loading within the 3-way valve tightening spiral spring up and down the stretch, regulate the stretch of the spring, spring is too large will check valve can't open;
6, the filling speed is too fast, throttle valve, regulate the filling speed down filling speed;
7, all card hoop, hose is sealed, check and correction;
8, magnetic switch is loose, please lock after each adjusted the quantity.
Proper maintenance can be done after find out the cause of the problem, if the filler filler not divide evenly, at the end of the joint tighten, leak phenomenon, can be further tighten if rotating machine is normal, but without repackaging liquid discharge.
First check valve inside the foreign body, such as cleaning immediately;
Check valves within the upper and lower two thimbles place is wrong, the correct method should be both plunger head down, may not be installed backwards.
If the boot after the crank rotating properly.
All the above is to introduce the content, hope to be of help.
If you want to learn more knowledge, you can visit our website, we will provide you with more professional information.