Common cans of filling machine malfunction and solution
What are the common faults using cans of filling machine?
These problems become more important in beverage filling machine use common sense, let's understand the cans of filling machine failure phenomenon causes and elimination methods.
1, after startup, display controller LCD screen no display.
The cause of the problem: if there is a electric power socket;
Whether the power plug fall off;
The fuse loose or fuse.
Troubleshooting: insert the plug again;
Reinstall or replacing the fuse;
Pay attention to the fuse must be in accordance with the requirements of the specifications of the book.
Note: to check and determine what is the cause of burn out the fuse.
2, after startup, the display shows the correct and instructions is running, but not turn pump impeller.
The cause of the problem: the pump head roller is jammed;
No stop bottle filling line not connected or not right level;
Driver circuit board.
Troubleshooting: the pump head installed as required;
There can be no stop bottle filling line connected and level is correct;
Check the circuit board.
Note: circuit board repair, it is best to repair by the supplier or company.
3, pump wheel rotation, but can't conveying fluid.
The cause of the problem: hose not pressure in place;
Hose damage leakage.
Troubleshooting: adjust the adjusting screw of the pump head cover;
Replace the new hose.
4, hose while working with roller slide to one side.
The cause of the problem: the hose is not fixed good troubleshooting: connect the hose with a tee and hung on the fixed screw or tube kaka.