Cutting accuracy is an important part of how good the laser cutting machine, but the precision of laser cutting is not entirely depends on the device itself, but is composed of various factors, mainly has the following several factors: 1, after focusing laser beam by the size of the light spot.
Gathered after laser beam of light is smaller, the higher the cutting precision, especially for smaller kerf width, the smallest flare up to 0.
2, the workbench of precision decides the repetition of cutting precision.
The workbench accuracy is higher, the higher the accuracy of the cutting.
3, the thickness of the workpiece, the greater the accuracy is lower, the greater the kerf width.
Because a laser beam to conical, kerf is tapered, the thickness of 0.
3 mm stainless steel is more than 2 mm smaller kerf width.
4, workpiece material had certain influence on the laser cutting accuracy.
Same case, stainless steel than aluminum high cutting precision, smooth some aspects.
Machining error size are often encountered in using the laser cutting machine for processing the fault, the fault influence both the production efficiency, increased the cost of production.
The cause of fault processing size error the main areas: 1.
The signal is not normal.
At this point the line needs to be replaced.
Equipment and computer bad earth.
Right now you need to equipment and computer good grounding.
Computer doesn't run well.
This needs to be repaired or replaced computer computer.
Computer operating system fault or infected with the virus.
Need to reinstall the operating system or killing the virus.
Application software is not normal.
Then you need to install the software and the motion control card driver software.
Power supply is not stable, or by the jamming signal.
The need to add stabilizer or eliminate interference signal.
Processing program to write is not correct.
At this point need to check and repair process.
Processing parameter setting is not correct.
To set the correct processing parameters.
Recommendation: laser cutting equipment discount bargain offer 4007001618 【
Metal laser cutting equipment 】
It is mainly used for cutting stainless steel, carbon steel, aluminum, copper, aluminum, iron, gold, silver etc. Thickness is 1.
0 ~ 25 mm plate;
Stainless steel laser cutting equipment 】
Classic gantry double drive structure of stable and reliable, automatic switching table, at the same time of cutting up and down on another table, convenient and quick to save time;
Optical fiber laser cutting 】
With high-speed movement speed, acceleration and dynamic performance, is laser for efficient and specialized research and development of a product, its cutting 0.
The speed of 5 mm stainless steel reached 100 m/min.
Carbon steel sheet metal laser cutting 】
Specializing in sheet metal processing industry demand for sheet of processing in the field of research and development design of laser processing equipment, it has a very high cost performance, with CNC system control, efficiency is much higher than in other laser cutting equipment for the board drive mode control.
More CNC laser cutting machine laser cutting laser cutting equipment