The fiber laser marking machine uses a fiber laser to output laser, and then realizes the marking function through a high-speed scanning mirror system.
The laser marking machine has high photoelectric conversion rate, long service life, easy maintenance, air cooling, small size of the whole machine, good output beam quality, high reliability, and fast marking speed, greatly improving the processing efficiency.
High-precision three-dimensional positioning technology, high-speed focusing and scanning system, laser beam basic mode, short pulse, high peak power and high repetition frequency bring satisfactory marking effect to customers.
Application Scope of fiber laser marking machine: widely used in metal materials and some non-metallic materials, especially suitable for some fields requiring finer, higher precision and higher smoothness, widely used in electronics separation components, integrated circuits (IC)
Electrical circuits, mobile communications, precision instruments, personalized gift customization, glasses clocks, computer keyboards, jewelry accessories, hardware products, kitchen utensils, tool accessories, auto parts, plastic buttons, plumbing accessories, PVC laser Marking of graphics and characters in many fields such as pipes, medical devices, packaging bottles and cans, sanitary ware, etc, and mass production line operations.
Said so much about the introduction of fiber laser marking machine, then you really will operate the fiber laser marking machine?
Today, Shenzhen laser Xiaobian for everyone to answer the laser marking machine to play the picture tutorial method: below we will directly enter the theme, first prepare a high-definition photo (Low photo pixels are too low to produce good results)
, Imported into the laser marking machine software, and then we set the relevant parameters.
First of all, fix the DPI value, which is simply a pixel point. The higher the value set inside, the better the effect will be and the relative time will be slow. The commonly set value here is 300-
About 600, of course, you can set higher, here you can carry out relevant parameters.
Then we have to set the relevant photo parameters, in most cases we have to set the photo reversal and dot mode (
There will also be cases where reversal is not selected, and reversal needs to be set under normal circumstances)
, Set to enter the extension, check the lighting treatment, contrast adjustment is to control the ideal effect of the photo, the white area is not marked, the black area is marked.
The following is a look at the scanning mode. Here I often use the dot mode. I set it to 0.
5. Bidirectional scanning is generally not recommended. If it is too slow, left and right scanning will not be used to adjust the power.
The rightmost speed is set to about 2000 and the power is about 40 (
According to the product material to determine the power size here set 40 power is a reference, mobile phone shell photo, the power can be set higher)
, The frequency is about 30, the frequency size setting problem, the greater the frequency, the denser the point of the laser.
The following figure shows the approximate parameters of a photo, but there is one. Each photo needs to adjust the contrast.