China's Leading Beverage Bottling Equipment Manufacturer

ShenZhen J&D Drinking Water Equipment Co., Ltd.

ZhangJiaGang  J&D  Packing  Machinery  Co.,  Ltd.

application-bottle filling machine- blow moulding machine- water treatment equipment-JD WATER-img



desk top type water dispenser

Precautions and maintenance of automatic electromagnetic

by:J&D WATER     2019-12-23
1. It is not suitable for metal containers and metal covers, let alone press the start button on a metal table, otherwise the machine will be damaged. 2. Before turning on the power, you must insert the induction aviation plug and tighten the screws. 3. Use single-phase three-wire power cords. For operator safety, be sure to use single-phase three-wire power sockets. The ground in the workplace must be dry to maintain insulation. 4. Equipped with automatic thermal protection for temperature overheating. When the temperature inside the machine is overheating, the buzzer in the machine will beep long and the yellow indicator light of “PRO.MD.” will be on. At this time, the main power switch should be turned off to cool down during standby. After the buzzer stops, continue to work. 5. During the work, you should often touch the surface of the sensor head to check whether it is overheating. If you find that your hands are hot, stop heating and wait until it cools down (you can turn off the power without cooling). When the 'WARMUP' green light is off, please Do not press the start button to avoid accidental triggering. After the machine is finished, please turn off the power switch on the panel. 6. It is equipped with fuse. 7. There is high voltage inside, the bottom plate is live. It is strictly forbidden to repair it by yourself to avoid electric shock. 8. If there is any exposed wire before use, stop using the machine, and use it after maintenance. 9. The equipment must not be impacted, stressed or wet during transportation, storage and use. 10. When the product is unpacked for inspection and acceptance, under normal transportation and intact packaging, if any part of the product is found to be inconsistent with the packing list, the company shall be promptly notified. 11. According to the instruction manual, the operation should be well understood beforehand. If any problem is found in the quality of the product, explain it to the company within the prescribed period. 清洁 Cleaning and maintenance of automatic electromagnetic induction aluminum foil sealing machine: Regularly clean the surface of the machine, the bottom plate and the lower mold slide, the groove, the upper platen pressure plate and the positioning rod (Note: the power must be turned off and the room temperature must be restored). 黄油 Lower die slide, pressure rod bearing, eccentric wheel, guide post, guide rail and other transmission parts are regularly added with butter to ensure the performance of the machine. How to clean the tooth knife: First plug the two drain holes of the lower mold with a cotton ball, pour boiling water into the groove of the lower mold until it is full, and then push the lower mold slide into place, press the upper mold down, Go to the low point of zui, let the knife soak for several minutes until cleaning, and repeat several times.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...